Magellan RTX3 Manual de instalación descargar pdf (Pagina 18)

Page 18 Programming

Stand Alone Use

The RTX3 can be used as a Stand Alone module. The programming sections

are the same as when used with an Esprit with the following exceptions:

• In Stand Alone mode, section [001], option [1] and option [2] will not affect

system use.

• Panic alarms can only be used to toggle PGMs on the RTX3 in Stand Alone

mode.

• Sections [301] to [332] do not have to be programmed.

NOTE: To program wireless transmitters in Stand Alone mode, you must use a

PX8 in conjunction with the RTX3. Refer to the PX8 Instructions for more

information.

Firmware Upgrade

The RTX3 firmware can be upgraded using either a serial connection or a four-

wire connection. For firmware upgrade instructions, refer to the Firmware

Upgrade Instructions document which is available at paradox.com > Software >

WinLoad. To upgrade an RTX3 on an Imperial system, refer to the RTX3

chapter in the Imperial System Guide.

Section Feature Details

[002] PGM output on panic

Option [0] No PGM output on panic alarm

Option [1] Toggle PGM 1 on panic alarm

Option [2] Toggle PGM 2 on panic alarm

Option [3] Toggle PGM 3 on panic alarm (default)

Option [4] Toggle PGM 4 on panic alarm

[003] RF lockout on panic

Option [0] No RF signal lockout on panic alarm (default)

Option [1] 30-second RF signal lockout on panic alarm

Option [2] 60-second RF signal lockout on panic alarm

Option [3] 90-second RF signal lockout on panic alarm

Option [4] 120-second RF signal lockout on panic alarm

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Magellan RTX3 Manual de instalación Pagina 18