Magellan MG5000 Guía de usuario descargar pdf (Pagina 8)

6 User Guide

Trouble Display

Your alarm system continuously monitors several trouble conditions that can be reported directly to your

monitoring station. When a trouble condition occurs, the [

TBL] key will illuminate. Press the [TBL] key, and the

keypad will illuminate a number corresponding to the trouble the system is experiencing. We strongly suggest

that you inform your monitoring station of the trouble and allow them to service your system.

NOTE: If the keypad emits a

BEEP every 5 seconds whenever a new trouble condition has occurred, press the

[

TBL] key to stop the “Trouble Beep”.

Accessing the Trouble Display

Key / LED

Lit

Trouble Type

Trouble Details

[2] Power Trouble (press [2] to view

the type of power trouble; the

corresponding key illuminate)

Three types of power trouble:

[1] The control panel is experiencing low/no battery.

[2] There is an AC failure on the control panel.

[3] There is an auxiliary overload on the control

panel.

[3] Bell Trouble There is a bell disconnect/overload on the control

panel.

Press

[TBL]

[4] Communication Trouble Your alarm system, if monitored, could not

communicate with the monitoring station.

[5] Tamper/Zone Wiring Failure A wiring problem is occurring on one or more zones.

[6] Module Tamper Trouble A module’s anti-tamper switch has been triggered.

[8] Timer Loss Your alarm system’s clock must be reprogrammed.

See Setting the Time and Date above to set your

system’s time and date.

[0 (10)] Module Supervision Loss One or more modules are no longer communicating

with the control panel.

IMPORTANT: Except for the Timer Loss trouble, contact your monitoring station or installer to resolve

the trouble condition.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Sin comentarios

Magellan MG5000 Guía de usuario Pagina 8