Magellan MG-6130 Manual de instalación descargar pdf (Pagina 5)

5

Diagram 3

3. Place the console back plate flush against

the mounted wall

plate as shown in Diagram 3.

4. Slide the Marine Magellan’s open slots

labeled F (Diagram 3) onto the wall plate’s

tabs labeled B.

5. Gently apply downward pressure to insert

the wall plates

tabs into Marine Magellan’s open slots.

6. Once the Marine Magellan’s power and

communication wires are hooked up

(Electrical Installation, Page 8), Insert two

screws through the wall plate

’s screw holes

labeled C and into holes labeled E (

Diagram 3 ) in the Marine Magellan back

plate. This will secure the console to the

wall.

Artion GSM Module

It is important that the GSM communication

module be mounted in such a location to

allow accessibility without obvious visibility.

Follow the steps below.

1.) Establish a proper location

2.) Mark the necessary holes to mount the

Artion and allow wiring access.

3.) Drill the mounting holes

4.) Drill the 5/8 wiring access hole

5.) Screw in the top two screws on the

left and right side of the area. Leave

approximately 1/8 inch between the wall

and the underside of the screw head.

6.) Feed your power, trigger and

communication wires through the wiring

hole.

7.) Place the GSM cellular module onto

the top two screws matching up the

respective holes and push downwards

to lock the unit into place.

8.) Depress the two tabs at the base of

the GSM cellular module and remove

the top Cover.

9.) Screw the final two screws on the

bottom of the GSM cellular module.

10.) Place cover back on Artion.

Artion Battery Backup

This case should be mounted in the vicinity

of the Artion. There are four screw holes

inside the metal case at all corners

(Diagram 5).

1 2 3 4 5 6 7 8 9 10 ... 43 44

Comentarios a estos manuales

Sin comentarios