Magellan MSS Manual de instalación descargar pdf (Pagina 10)

to help determine if a disturbance exists .)

STEP 5 – Use a measuring tape to center the plate

on the roof.

Step 6 – Mark the corners of the dish. This is used

later on to accurately lower the mounting plate onto

sealant.

STEP 7 – Mark all screw holes for drilling pilot

holes. Note that you don’t need to use the factory

holes, and can drill your own in the mounting

plate.

STEP 8 – The drill bit used to create pilot holes

must be smaller than the threads of the screwbolts

used…but the size can’t be too small or you could

crack fiberglass roofs. The size the drill should

be is the size of the shank of the screwbolt.

Self-Tapping screwbolts (as shown by the silver screwbolt in Step 8) are recommended for

installations because of their “cutting” edge. Pilot holes are always required, especially on

fiberglass roofs.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Sin comentarios

Magellan MSS Manual de instalación Pagina 10