Magellan MSS Manual de instalación descargar pdf (Pagina 18)

INTERNAL WIRING

Below is a schematic of a correctly connected MAGELLAN system.

There are 5 cables that come down from the MAGELLAN that connect to 3 different components.

1. The RX Coax Cable that connects to the DW6000 Modem

2. The TX Coax Cable that connects to the DW6000 Modem.

3. The Ethernet Cable that connects to the Router (Port 1-4).

4. A Phone Cable that connects the remote control.

5. Power Cable that supplies the dish with 15VDC power (via a supplied 15V Power Supply)

The MAGELLAN was designed to work well when all components are turned off and on from a

power bar switch. Note that a computer is not part of the MAGELLAN system.

DRYDOCKING - For those who need to draw as little power as possible, the customer may turn off

just the MAGELLAN (by simply unplugging it) and it will not affect Internet connectivity. Of course

the dish must have acquired satellite before it can be unplugged.

Before the cables can be cut to length, you must decide where in the rig all equipment is going.

Remember, the MAGELLAN is a self-contained Wi-Fi system which means that all components may

be located in the same cabinet and connected to the same power bar. Also, it is wise to mount the

Linksys Wi-Fi Access Point in cabinet near the ceiling for better exterior reception. Please work with

the customer for the best location of system components.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

Sin comentarios

Magellan MSS Manual de instalación Pagina 18