Magellan MG5000 Manual de instalación descargar pdf (Pagina 45)

MG5000 41

Option [5] OFF = PGM Pulse once every 30 seconds disabled (default)

Option [5] ON = PGM Pulse once every 30 seconds enabled

When armed, the PGM will pulse once every 30 seconds.

Option [6] OFF = PGM Pulse on any alarm disabled (default)

Option [6] ON = PGM Pulse on any alarm enabled

This option sets the PGMs to pulse on any alarm.

Option [7] OFF = PGM Pulse on any alarm Partition 1(default)

Option [7] ON = PGM Pulse on any alarm Partition 2

Program PGMs to pulse during an alarm for either partition. With this feature enabled, and in combination with the Follow Arm/

Stay Arm/Sleep Arm PGM type, the PGM will mimic the Arm LED.

10.5 PGM Programming

Sections [301] to [316]

The programming of the PGMs is accomplished in two steps:

1. Assign the PGMs to the Magellan MG5000.

2. Program the zones.

PGM Programming can be executed through the Installer Quick Menu in the MG5000 Programming Guide.

10.6 Viewing the PGM Signal Strength

Sections [321] to [336]

Once PGMs have been installed and assigned to the Magellan MG5000, the signal strength of each PGM can be verified in

sections [321] to [336]. Sometimes moving the PGM or control panel by a small amount will greatly increase the signal reception.

How Do I Assign PGMs to the MG5000?

1) Press the [ENTER] key.

2) Enter your [

INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (default 1111/111111)

3) Enter the desired [

SECTION NUMBER] (from sections [301] to [316]).

4) Enter the 6-digit [SERIAL NUMBER] of the PGM.

How Do I Delete Assigned PGMs?

1) Press the [ENTER] key.

2) Enter your [INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (default 1111/111111)

3) Enter the desired [

SECTION NUMBER] (from sections [301] to [316]).

4) Press the [0] key six times to clear the serial number.

How Do I View a Wireless Transmitter’s Signal Strength?

1) Press the [ENTER] key.

2) Enter your [INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (default 1111/111111)

3) Enter the desired [SECTION NUMBER] (from sections [321] to [336]).

4) Press the transmitter’s anti-tamper switch or open the corresponding zone.

5) The keypad will illuminate numbers 1 to 10.

Signal Strength Indicator

8 to 10 / 3 beeps = Best signal 5 to 7 / 2 beeps = Average signal 1 to 4 / 1 beep = Weak signal (Relocate)

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 55 56

Sin comentarios

Magellan MG5000 Manual de instalación Pagina 45