Magellan MG5000 Manual de instalación descargar pdf (Pagina 7)

MG5000 3

Figure 2: Magellan MG5000 Control Panel Overview

Refer to Single Zone

Inputs on page 6

Refer to AC Power

on page 2.

For the keypad’s zone

configurations, refer to page 6.

If EOL is enabled: see section

[706] option [2]. Also refer to

Keypad Zone Connections on

page 6.

AUX Power

Refer to transformer requirements on page 2 for Aux. Power

Output. To connect additional wiring to auxiliary power, use

the red (+) and black (-) keypad connectors. Auxiliary power

will shut down if current exceeds 1.1A. If the auxiliary output

is overloaded and is shut down, you must disconnect all

loads from the output for at least 10 seconds before

reconnecting any load back to the auxiliary output.

To provide maximum lightning protection

we strongly recommend having separate

earth connections for the dialer and zone

ground terminals.

To metallic

enclosure

Ground

clamp

AWG#14 single

conductor solid

copper wire

Cold water

pipe

grounding

The "

BELL" output will

shutdown if the current

exceeds 3A.

Warning:

Disconnect

telephone line

before servicing.

Four pin connector

can be used for

quick installation of a

MG5000 keypad.

Warning:

Do not cut, bend or

alter the antennas

and ensure that

electrical wires do

not cross over the

antennae, as this

may affect signal

reception.

Paradox Memory

Key (PMC-3,

PMC-4)

Antennas"RX" & “TX” LED:

Flashes quickly when

receiving or transmitting

RF signals from

wireless devices.

"STATUS" LED:

Flash once every second = Normal

Flashes ON 1 second and OFF 1 second =

Any trouble

Always ON = Panel is using phone line

Fast flash 6 seconds after power up = Installer

lock enabled

This equipment must be installed and

maintained by qualified service personnel only.

For UL and C-UL warnings, refer to the UL and

C-UL Warnings section at the back of the

MG5000 Reference & Installation Manual.

Used for In-Field Firmware upgrade

through a 306USB Direct Connect

Interface. See Connecting Magellan

to Winload on page 45 for details.

Coming soon: VDMP3 plug-

in voice module for voice

reporting

Press and hold the RESET

button for five seconds. The

STATUS LED will start

flashing. Within 2 seconds

of this flashing, press the

reset switch again. The

panel will reset to default

and restart.

The sum of the

current drawn

from the BELL and

AUX must be

limited to 1.3A

(40VA transformer

strongly

recommended).

Connection for Self-Contained Bell/Siren

Warning:

Max. amount of keypads = 15 keypads

Max. current = 700 mA

Max. distance of keypad from panel = 76m (250 feet)

Max. total run of wire = 230m (750 feet)

Charging and

Battery test LED

Exceeding this limit will overload the panel power supply

and lead to complete system shutdown.

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Comentarios a estos manuales

Sin comentarios

Magellan MG5000 Manual de instalación Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Magellan MG5000