Magellan MG5000 Manual de instalación descargar pdf (Pagina 50)

Part 13: User Operation

13.1 Alarm Display

If an alarm has occurred on a zone, the respective zone LED will flash, the [MEM] key will light up, and the zones will be stored in

memory. These respective LEDs will continue to flash until disarming even if the zones are restored. To exit this mode and switch

to live display mode before disarming, press the [

CLEAR] key. Once the system is disarmed, the zones’ LEDs will turn off, while

the [MEM] key remains lit. Press the [MEM] key to illuminate the LEDs corresponding to the zones that were in alarm. The alarm

memory will be erased when the next alarm occurs and after a valid code is entered.

13.2 Trouble Display

Press the [TBL] key to view the Trouble Display. Please note that the keypad can be programmed to emit a beep every 5 seconds

whenever a new trouble condition has occurred. Press the [

TBL] key to stop the beeping.

To view the sub-menu, press the corresponding key in the main menu.

Main Menu Trouble Sub-Menu Trouble Menu

[1] Wireless zone low battery [1] to [32] Zones in low battery

[2] Power trouble [1] Low/No battery on the control panel

[2] AC failure on control panel

[3] Auxiliary overload on control panel

[4] Wireless keypad AC failure

[5] Wireless keypad battery failure

[6] Wireless repeater AC failure

[7] Wireless repeater battery failure

[3] Bell trouble [1] Bell disconnect on control panel

[2] Bell overload on control panel

[4] Communication trouble [1] Telephone Line Monitoring on control panel

[2] Fail to communicate on Monitoring Telephone 1 on control panel

[3] Fail to communicate on Monitoring Telephone 2 on control panel

[4] Fail to communicate on pager telephone on control panel

[5] Fail to communicate on voice telephone on control panel

[6] Fail to communicate with PC on control panel

[5] Tamper and zone wiring failure [1] to [32] Zones in tamper and zone wiring failure

[6] Module tamper trouble [1] MG-2WPGM

[2] Keypad bus

[5] Wireless keypad

[7] Fire loop trouble [1] to [32] Zones in fire loop trouble

[8] Timer loss

[9] Wireless zone supervision loss [1] to [32] Zones in supervision lost

[

STAY] RF interference trouble

[0 (10)] or [10] Module supervision loss [1] MG-2WPGM

[2] Keypad bus (Panel reset will not clear this trouble, clear it in

section [955])

[5] Wireless keypad supervision failure

[6] Wireless repeater supervision failure

[16] Keypad fault (MG32LED/MG32LRF only)

[

SLEEP] Keypad fault (MG10LEDV/H only)

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56

Comentarios a estos manuales

Sin comentarios

Magellan MG5000 Manual de instalación Pagina 50

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Magellan MG5000